Floor door stop door suction installation-introduction to the floor door stop method

The door stopper is a small device behind each door that prevents the door from hitting the wall. Although the door stopper is small, it has a great effect. The door stopper can reduce noise and prevent the door from colliding with the wall and causing damage to the door or wall.

Floor door suction installation

Floor door stopper installation-a brief description of the door stopper

The door stopper is also commonly known as door touch. It is also a device that sucks and locates the door leaf after it is opened to prevent it from being closed by wind blowing or touching the door leaf. Door stoppers are divided into permanent magnetic door stoppers and electromagnetic door stoppers. Permanent magnetic door stoppers are generally used in ordinary doors and can only be controlled manually; electromagnetic door stoppers are used in fire doors and other electronically controlled door and window equipment, which have both manual control and automatic control. control function.



Floor door stopper installation-door stopper installation method

First, confirm with the owner whether the door stopper is installed on the ground or on the wall; then open the door to the maximum position required to test whether the door stopper function is reasonable and whether the distance between the door stopper and the door is appropriate. Position the door After the position is roughly positioned, open the door and try whether the actual operation is reasonable, including whether the door stopper enters a little bit or comes out a little bit, what is the specific angle of the door stopper; after finalizing the position, locate it on the floor and floor tiles, first Locate the stop position of the door, use a pencil to confirm the position of the door on the floor tiles, the worker master uses a pencil to draw a line on the ground, first confirm the final position of the door open, and then confirm the final installation position of the door stopper; the worker master is doing the door stopper The mark of the last position, the reason why it needs to be positioned twice, to locate both the door and the door stopper, is for better installation. This is the best way to confirm the angle of the door stopper and the door opening; the next job is to drill an electric drill and drill the installation hole of the door stopper on the ground. The worker is drilling holes in the floor tiles, and the Aijia masonry worker installs it. The tiles are also really strong. This door stopper only needs to drill a hole; the fixed end of the door stopper is being installed, and the screw on it is tightened. The door stopper is divided into a fixed end and a door end. The fixed end needs to be installed. Tighten the screws before, and then use the included internal angle wrench to tighten the screws on the ground or the wall; using a small internal angle to screw the screws is a fine job, no experience, and then go through confirming the position, punching, and After the assembly procedure, the next task is to install the fixed end on the ground. Use the included internal angle tool to tighten the screws on the fixed end, and the door stopper will be automatically installed; the door stopper end on the door can be tightened with screws. It is useless to install the fixed end of the door to absorb light. It is necessary to install the door. The key is to locate the door end. The method is to open the door to the maximum, then find the exact position on the door, and tighten the door end door with screws. Suction; Fine-tune the angle of the fixed end of the door stopper and then fully tighten it. The last step in the installation of the door stopper is to fine-tune the angle of the door stopper to make it all fit with the door stopper, and finally tighten the screw thoroughly.

Floor door stopper installation-door stopper maintenance

To prevent bumps during the handling of the door stopper; when cleaning the door stopper, try not to wet the metal plating parts. First, use a soft cloth or dry cotton yarn to remove dust, and then wipe with a dry cloth to keep it dry. Do not use colored cleaning agents, or forcefully damage the surface layer.

Post time: Jun-29-2021